At T. Hamilton we make traditional prosthetic solutions for total or partial loss of teeth.

A replacement of the full dentition will typically include an acrylic prosthesis assuming that there is a certain amount of bone remaining after the teeth are gone to 'hold' prosthesis. Some cases - where there is not enough bone left - may require insertion of implants with a snap fastener in which we can then put the prosthesis firmly.

For partial loss of teeth this traditional solution is built on a steel construction with custom brackets surrounding some of the remaining teeth. There is also a new and flexible prosthesis which are easier to manufacture - and thus cheaper - but has some limitations regarding the expansion of plastic teeth. This system is called sunflex and you can read more it by following this link: http://www.sunflexpartials.com/SFP_SV/lab-sv.html